CORKS - #2 FOR 7/16" HOLES, 1000/BAG

FEATURES

- Tapered corks designed to fit and help to seal holes drilled when treating for termites.

- These are designed to fit into holes which are drilled with a 7/16" bit.

- Cork size listed is measured at the largest diameter of the cork.

- They should be pushed down about 1/4" to 3/8" below the beginning of the hole and then a sealant like cement, mortar or silicone should be applied over the top to properly seal it up.

- The plug will essentially provide a marking used during application to let you know where you have treated as well as keep down both liquid and foam termiticide which tends to flow sideways and then holes which have already been treated.

- The plug will then serve as a backing for the sealant allowing it to set and dry properly.